 Specifications |
| |
IAP-120 |
IAP-120+ |
| Physical Ports |
|
|
| 10/100Base-T(X) Ports in RJ45 Auto MDI/MDIX |
2 |
| P.O.E. PD port |
Present at ETH2
Fully compliant with IEEE 802.3af Power
Device specifi cation
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min |
| WLAN interface |
|
|
| Operating Mode |
AP/Bridge/Repeater/AP-Client |
| Antenna and connector |
2dBi antenna on reverse SMA connector |
| Radio Frequency Type |
DSSS, OFDM |
| Modulation |
IEEE802.11b : CCK, DQPSK, DBPSK
IEEE802.11g : OFDM with BPSK, QPSK, 16QAM, 64QAM |
| Frequency Band |
America/FCC : 2.412~2.462 GHz (11 channels)
Europe CE/ETSI : 2.412~2.472 Ghz (13 channels)
|
| Transmission Rate |
IEEE802.11b : 1/ 2/ 5.5/ 11 Mbps
IEEE802.11g : 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps |
| Transmit Power |
IEEE802.11b/g : 20dBm Max |
| Receiver Sensitivity |
-81dBm @ 11Mbps, PER< 8%;
-64dBm @ 54Mbps, PER< 10% |
| Encryption Security |
WEP : (64-bit ,128-bit key supported)
WPA :
WPA2 : 802.11i(WEP and AES encryption)
PSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption |
| Wireless Security |
SSID broadcast disable |
| Protocol Support |
|
|
| Protocol |
ARP, BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D) |
| LED Indicators |
|
|
| Power Indicator |
PWR 1(2)(P.O.E.) / Ready :
Red On : Power is on and booting up.
Green On : Power is on and functioning Normally. |
| 10/100TX RJ45 Port Indicator |
Green for port Link/Act at 100Mbps. Amber for port Link/Act at 10Mbps |
| WLAN LEDs |
WLAN Link /ACT : Green
WLAN Strength : 1<25%, 2<50%, 3<75%, 4<100% |
| Fault |
Red : Ethernet link down or power down |
| Fault contact |
|
|
| Relay |
Relay output to carry capacity of 1A at 24VDC |
| Power |
|
|
| Redundant Input Power |
Dual DC inputs. 12-48VDC on 6-pin terminal block |
Triple DC inputs, 48VDC from PoE and Dual 12~48VDC on 6-pin terminal block |
| Power Consumption (Typ.) |
6 Watts |
| Overload Current Protection |
Present |
| Reverse Polarity Protection |
Present on terminal block |
| Physical Characteristic |
|
|
| Enclosure |
IP-30 |
| Dimension (W x D x H) |
54.2(W) x 106.1(D) x 145.4(H) mm (2.13x4.18x5.72 inch.) |
| Weight (g) |
800 g |
804 g |
| Environmental |
|
| Storage Temperature |
-40 to 85°C (-40 to 185°F) |
| Operating Temperature |
-10 to 55°C (14 to 131°F) |
| Operating Humidity |
5% to 95% Non-condensing |
| Regulatory approvals |
|
|
| EMI |
FCC Part 15, CISPR (EN55022) class A |
| EMS |
EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS),EN61000-4-8, EN61000-4-11 |
| Shock |
IEC60068-2-27 |
| Free Fall |
IEC60068-2-32 |
| Vibration |
IEC60068-2-6 |
| Safety |
EN60950-1 |
| MTBF (Hours) (MIL-HDBK-217F2, GB, GC, 25°C ) |
352,982 |
352,594 |
| Warranty |
3 years |
